The Valve Wizard

How to design valve amplifiers

Designing Valve Guitar Amplifiers

Available in hardback greyscale, or softback colour, 322 pages.
(There is no electronic version)

Available from Lulu.com and Amazon.


Synopsis:
Designing Valve Guitar Amplifiers is the most comprehensive guide to the design of valve-based amplifiers for musical instrument use, in a single volume. From the input jack to the loudspeaker, this book discusses in detail the inner workings and practical design of every part of a conventional guitar amplifier, including the use of preamp valves, power valves, special effects, power supplies, practical construction, and much more.

Whether you are a hobbyist or a professional engineer, this book will help you to manipulate distortion and maximise performance for the perfect guitar tone. With easy-to-read explanations, minimal math, and over 300 diagrams and figures, it asserts itself as the essential handbook for every valve amp enthusiast.

View the full contents list here.

Chapter list:
1: The Triode Gain Stage
2: More Preamp Essentials
3: Tone Controls
4: The Cathode Follower
5: The Pentode Gain Stage
6: The Cathodyne Phase Inverter
7: The Long-Tailed Pair
8: Tremolo
9: Spring Reverb
10: Single-Ended Output Stages
11: Push-Pull Output Stages
12: The Power Supply
13: Signal Switching
14: Layout and Grounding

Errata: (These apply only to copies ordered before December 2025)
On page 233 it read: A better option for the output stage is to add catching diodes, illustrated in fig. 11.15... The figure number should read 11.16.
On page 240 it reads: The final circuit is shown in fig. 11.21. The figure number should read 11.22.
On page 240 there are two figures labelled "fig. 11.23"; the second of these should be labelled fig. 11.24.
On page 242 it reads: We know from bench testing that the open-loop gain of the circuit (fig. 11.22)... The figure number should read 11.23.
On page 317, the upper curve in fig. 15.5 should be labelled 400V, not 350V.